Perko 1-1/2" IPS Intake Strainer BronzePERKO Intake Strainer are designed for easy installation and cleaning.Features include mounting lugs cast into both sides to assure universalmounting, four outside tie rods and a 316 stainless steel strainer basket tominimize electrolysis. Screen hole diameter .077 inches, 46% open area.Hinged lugs for the cast bronze cover permit easy removal and cleaning of the strainer basket. A drain plug in the bottom casting is provided foreasily removing sediment and draining for winterizing.Cast bronze.Please note: Spare parts for this item are NOT interchangeable withthe Perko 0593 Flushing Strainer.Technical Information:
Pipe Size Inches: 1-1/2
Height Overall Inches: 11-1/2
Width Overall Inches: 7-1/4
Model Number: 0493008PLB
Dimensions Cylinder Inches: 6 x 8
Dimensions Basket Inches: 3-5/16 x 8-7/16
Open Area to Pipe Size Ratio: 17.1
Ship Weight: 14.1
Spare Gasket Kit: 0493DP999M (or) 99R
Made in the USA
In-Line 4" Bilge Blower - 24VXylem’s Rule In-Line Blowers provide ventilation for boat bilges, engine compartments, galleys and heads. Designed for efficient, high-output operation, these blowers feature our exclusive front and rear shaft seals and corrosion-resistant motor housings for long life. Compact and easy to install on any flat surface, Rule In-Line Blowers provide higher airflow and lower amperage draw.Features:
Efficient high-volume air flow
Quiet operation
Low amp draw
Slip-on inlet and outlet ducting connections
Sealed motor shaft for moisture protection
Corrosion-resistant nickel-plated motor housing
IMCI (CE)
USCG 183.410 Compliant: Ignition protected
WARNING: This product can expose you to chemicals including STYRENE which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
Amazon Universal Manual Bilge PumpFeatures:
Connections: – for 38 mm (1½ “) bore hose
Dimensions: – 240mm long, 210mm wide, 150mm high, with 260mm handle (nominal dimensions for variable pump configuration)
Output: – up to 100 litres/minute (22 gallons/minute)
Flow direction reversible by exchanging inlet and outlet ports
Quick-release clamp ring for rapid disassembly
Optional through-deck kit permits operation from inside or outside the cabin
Push-fit inlet and outlet elbows (1 supplied with pump) increase flexibility of installation
Stainless steel handle with bulkhead clips
Self-priming up to 4m
Packaged Dimensions: L:24.00 x H:16.00 x W:24.00cm
Actual Weight: 1.36 Kg (Approx. 1.86 Kg packed)
Mastercraft Ballast Pump - 12VThe Jabsco Wake/Surf boat Ballast pump is the direct replacement for Mastercraft part number 300249. The Jabsco pump comes standard with a green Run Dry Impeller and has the standard electrical quick connector already installed. Just connect your hoses, mount the pump in the boat, plug the power leads together and your surfing and wakeboarding again.Features:
Same electrical connection as original OEM
Same mounting as the OEM unit, no need to drill more holes
The leader for flexible Impeller Ballast Pumps
WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications:
Volts: 12v
Box Dimensions: 5"H x 6"W x 10"L WT: 6.8 lbs
UPC: 671880629003
Seaward 6 Gallon Hot Water Heater - Stainless Steel - 120V - 1500WWhale Electric Water Heaters includes model with the very latest technology. All heaters are manufactured from the highest quality materials and designed to specifically withstand harsh marine conditions.Water Heaters with a Stainless Steel cover offer high levels of corrosion resistance with a modern stainless steel finish. These heaters are a bit lighter than those wearing the galvanized outer cover and heavier than the epoxy coated versions.Features and Benefits:
Horizontal Mounting only
Robust Manufacturing
Hold down brackets welded to inner tank
Safety controls
Integrated pressure relief valve
Temperature and pressure drain tube included
Magnesium anodes available separately
Recommended to prevent corrosion and ensure a longer Water Heater life
Sturdy, robust exteriors
Ignition protected
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications:
Gallons: 6
Heat Exchanger: No
Volts: 120v
Box Dimensions: 14"H x 14"W x 22"L WT: 23.6 lbs
UPC: 766478948267
Brochure (pdf)
FW0814 WaterMaster Automatic Pressure Pump - 8L - 30PSI - 12VWaterMaster FW0814 is a pump from Whale with a compact sleek design that is easy to install and maintain.Features:
8L per minute flow rate
30PSI
12V
Internal pressure switch controlled (no external switching required)
Fully sealed protective motor housing
Completely integrated electronics
Runs dry without damage (within reason)
Includes a strainer to protect the pump from debris
Self priming upto 3m (10ft)
Easy installation - suitable for 15mm quick connect plumbing or 1/2" hosetails
Suitable for use with salt or fresh water
Quit operation
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications:
Gallons Per Minute: 2 GPM
Max PSI: 30
Volts: 12v
Box Dimensions: 6"H x 8"W x 10"L WT: 4.1 lbs
UPC: 766478946881
Motor/Pump Assembly f/37010 Series Electric ToiletsJabsco's spare motor/pump assembly is for the 37010 Series Electric Toilets. Includes:
Maceratior housing
12V motor
Centrifugal impeller
Flexible impeller slinger
Gaskets
Seals
Screws
O-rings
WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov. Specifications:
Type: Misc
Box Dimensions: 6"H x 8"W x 10"L WT: 4.95 lbs
UPC: 671880032834
Shower Drain and Bilge PumpRobust Single Diaphragm Design Sink & Shower Drain PumpFlow rate: Nominal 16 Litres/min (4.2 US gallons/min)Self-priming from dry up to 3m (10ft)Features:
Flexible installation
No filter required
Compact and simple design
Dry running capability
Relevant Standards: ISO 8846 MARINE and USCG Regulations for Ignition Protection ISO 8849 MARINE Bilge Pump Standard
Built to ISO 15083 Specification
Meets BSEN 50081 (Electro Magnetic Compatibility)
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov. Specifications:
Gallons Per Minute: 4.2 GPM
Inlet Size: 3/4"
Outlet Size: 3/4"
Suction Lift (ft.): 10'
Volts: 12v
Type: Shower Drains
Box Dimensions: 6"H x 8"W x 14"L WT: 6.65 lbs
UPC: 671880581561
Owner's Manual (pdf)
Handy Boy Utility PumpVersatile polished brass multi-purpose hand pump
Drain, fill or top up engine and gearbox oil
Overcomes problem of hard to reach drain plugs and filler caps
Oil and corrosion resistant brass neoprene construction with up to 1 1/2 GPM output
1001 other uses on any boat
WARNING: This product can expose you to chemicals including STYRENE which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov. Specifications:
Gallons Per Minute: 1.5 GPM
Outlet Size: 1/2"
Type: Manual
Box Dimensions: 2"H x 9"W x 16"L WT: 1.8 lbs
UPC: 671880028288
Quick Guide (pdf)