Cable for Smart BMS CL 12-100 to MultiPlus This cable will allow the MultiPlus 500VA – 1600VA, MultiPlus Compact 800VA – 2kVA and MultiPlus-II models to be used with BMS products that have no VE.Bus interface, such as the Smart BMS CL 12-100 and the small BMS. These MultiPlus models can be controlled from the Load/Charge Disconnect outputs and Load/Charger outputs respectively. The cable must be wired to the remote on/off connector of the MultiPlus models:
When used with the MultiPlus 500VA-1200VA models connect the black wire to the ON terminal and the red wire to the (+) terminal.
When used with the MultiPlus Compact 800VA-2kVA models connect the black wire to the middle terminal and the red wire to the right (IN) terminal.
When used with the MultiPlus-II models connect the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal.
Both the Load/Charge Disconnect outputs of Smart BMS CL 12-100 and Load/Charger outputs of the small BMS must be in ‘High’ state in order for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then switch on and start charging (if connected to an AC power source).Please contact your dealer for any returns, repairs or support issues related to this product. Quick Guide (pdf)
Smart BMS CL 12/100 f/Victron LIFEPO4 Batteries 12VDC OnlyThe Smart BMS CL 12/100 is a Battery Management system for Victron lithium-iron-phosphate (LiFePO4) Smart Batteries. It has been specifically designed for 12V systems with a 12V alternator.The BMS CL 12/100 monitors and protects each individual battery cell within the battery (or battery bank) and will disconnect the alternator, charge sources, or DC loads in case of low battery voltage, high battery voltage, or over temperature.The dedicated alternator input provides current limiting and one-way traffic from the alternator into the battery, so any size alternator (and start battery) can be safely connected to the Smart Lithium battery or batteries.The BMS is also equipped with a remote on/off the connector, to turn the BMS (and the system) off via a remote switch, and a pre-alarm contact, to give a warning signal before the BMS will disconnect the batteries from the system.Please contact your dealer for any returns, repairs or support issues related to this product. Quick Guide (pdf)Owner's Manual (pdf)Brochure (pdf)
Busbar 150A 6P & Cover 6X 1/4" TerminalsBusbars are used for high current distribution and at the same time they provide connections for batteries and/or DC equipment.We offer a number of busbars with different current ratings, and a different number of connection terminals. Each busbar is fitted out with a removable protective cover. Quick Guide (pdf)
Busbar 250A 2P with 12 Screws & CoverBusbars are used for high current distribution and at the same time they provide connections for batteries and/or DC equipment.We offer a number of busbars with different current ratings, and a different number of connection terminals. Each busbar is fitted out with a removable protective cover. Quick Guide (pdf)
ChargeMaster Plus 24/20-3 Battery ChargerMake the most of your batteries with the ChargeMaster series, plugging in and charging anywhere in the world. Mastervolt’s ChargeMaster guarantees fast and complete charging of your batteries no matter where you are. Thanks to Mastervolt’s innovative 3-step+ charging process, batteries also perform better and last longer.All ChargeMasters can be easily connected to a MasterBus network with only one cable and one connection (with the exception of the ChargeMaster 12/10, ChargeMaster 12/15-2, and ChargeMaster 24/6). What’s more, you have the option for central, local, or remote monitoring, configuration, and control of your system.Clear DisplayA clearly lit display on the ChargeMaster provides all essential information: charge current, charge voltage, charge phase, and battery content measurement and/or battery condition measurement as a percentage of available Ah capacity. The display also provides an indication of MasterBus communication. Three buttons adjacent to the read-out panel allow for easy operating of the entire system. The ChargeMaster is available in various models to guarantee you the ideal battery charger for any situation and demand.Features:
For recreational and semi-professional use.
Suitable for any type of battery, including Lithium-Ion batteries.
3-Step+ charging technology for fast and complete charging also charges depleted batteries.
Memory function prevents overcharging in case of unreliable mains.
Safe and complete charging due to standard safety features.
Charging capacity up to 1000 Ah battery banks.
Easy to connect and quick to install.
Can charge multiple battery banks simultaneously.
Built-in system functionality (MasterBus) in combination with other Mastervolt products.
Clear control panel (with the exception of the ChargeMaster 12/10, ChargeMaster 12/15-2, and ChargeMaster 24/6).
Supplies your system without a battery.
Charging your batteries with every voltageThe Mastervolt ChargeMaster supplies a maximum capacity wherever you are via auto-ranging. Auto-ranging ensures perfect fully automatic operation anywhere in the world, regardless of the available mains voltage (90-265 V AC, 50 or 60 Hz). The 3-step+ charging technology guarantees fast and complete charging, while the cos phi 1-regulation gets the most out of limited generator capacity.Robust Connections Solid metal-to-metal connectors equipped with strain relief prevent corrosion and overheating.Charging multiple battery banksThe ChargeMaster series has three equal charge outputs. Those of the smaller ChargeMaster models are pre-installed with two meters of cable for a plug & play solution, while the heavier models have one full output (for example for your service battery) and two outputs of 10 A, ideal for your starter batteries.DC Power SupplyEven if the batteries are not connected, Mastervolt ChargeMaster battery chargers can provide a constant DC output allowing you to turn on lights or keep the fridge cold.Specifications:
Nominal output voltage: 24 V
Total charge current: 20 A at 28.8 V
Number of battery outlets: 3
Charge current second output: 20 A
Charge current third output: 20 A
Battery bank size: 40-200 Ah
Nominal input voltage: 120/230 V (90-265 V), 50/60 Hz
AC connection: Connector strips
Power supply mode: Yes
Galvanic isolation: Yes
Display/read-out: LED display
Specifications:
Charger Input - Voltage: 120/230v
Charger Output - Amps: 20a
Charger Output Voltage: 24v
Charging Banks: 3
Portable: No
Box Dimensions: 6"H x 12"W x 16"L WT: 9 lbs
UPC: 816882022890
Owner's Manual (pdf)
Busbar 600A 8P & Cover 8X 3/8" Plus 8X M8 TerminalsBusbars are used for high current distribution and at the same time they provide connections for batteries and/or DC equipment.We offer a number of busbars with different current ratings, and a different number of connection terminals. Each busbar is fitted out with a removable protective cover.Please contact your dealer for any returns, repairs or support issues related to this product. Quick Guide (pdf)
Busbar 150A 2P with 20 Screws & CoverBusbars are used for high current distribution and at the same time they provide connections for batteries and/or DC equipment.We offer a number of busbars with different current ratings, and a different number of connection terminals. Each busbar is fitted out with a removable protective cover. Quick Guide (pdf)
Busbar 250A 2P with 6 Screws & CoverBusbars are used for high current distribution and at the same time they provide connections for batteries and/or DC equipment.We offer a number of busbars with different current ratings, and a different number of connection terminals. Each busbar is fitted out with a removable protective cover. Quick Guide (pdf)
Marine Grade Spiral Wrap 1/2" x 100'Features:
Permits flexible routing of cable harnesses
Provides abrasion protection for wire and cable
Allows lead-outs at any point for the greatest ease of installation
Split loom temperature range is -40°F to 275°F / -40°C to 135°C
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications:
Type: Misc
Box Dimensions: 8"H x 12"W x 12"L WT: 2.15 lbs
UPC: 091887457063
Marine Grade Spiral Wrap 3/8" x 100'Features:
Permits flexible routing of cable harnesses
Provides abrasion protection for wire and cable
Allows lead-outs at any point for the greatest ease of installation
Split loom temperature range is -40°F to 275°F / -40°C to 135°C
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications:
Type: Misc
Box Dimensions: 5"H x 9"W x 12"L WT: 1.55 lbs
UPC: 091887456066
Self-Extinguishing Split Loom 3/8" x 10'Features:
Permits flexible routing of cable harnesses
Provides abrasion protection for wire and cable
Allows lead-outs at any point for the greatest ease of installation
Split loom temperature range is -40°F to 275°F / -40°C to 135°C
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications:
Type: Misc
Box Dimensions: 2"H x 5"W x 7"L WT: 0.1 lbs
UPC: 091887967470
Self-Extinguishing Split Loom 3/8" x 100'Features:
Permits flexible routing of cable harnesses
Provides abrasion protection for wire and cable
Allows lead-outs at any point for the greatest ease of installation
Split loom temperature range is -40°F to 275°F / -40°C to 135°C
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications:
Type: Misc
Box Dimensions: 9"H x 12"W x 12"L WT: 1.95 lbs
UPC: 091887967487