Electrical

Orion-TR 12/24-10A (240W) Isolated DC-DC ConverterIsolated Model - separate in and out (-) leads Remote On/Off TerminalThe remote on/off terminal eliminates the need for a high current switch in the input wiring. The remote on/off can be operated with a low power switch or for example the engine run/stop switch. All Models Are Short Circuit Proof and Can Be Paralleled to Increase Output CurrentAn unlimited number of units can be connected in parallel.  High Temperature Protected The output current will reduce at high ambient temperatures.  IP43 Protection When installed with the screw terminals oriented downward.  Screw Terminals No special tools are needed for installation.  Input Fuse (not replaceable) On 12 V and 24 V input models only.  Adjustable Output Voltage Not intended for battery charging (consider using an Orion-Tr Smart for battery charging).Specifications: Input Voltage Range: 8-17 V Under Voltage Shut Down: 7 V Under Voltage Restart: 7.5 V Nominal Output Voltage: 12.2 V Output Voltage Adjust Range: 10-15 V Output Voltage Tolerance: +/- 0,2 V Output Noise: 2 mV rms Cont. Output Current at Nominal Output Voltage and 40 Degrees C: 10 A Maximum Output Current (10 S) at Nominal Output Voltage: 15 A Short Circuit Output Current: 25 A Cont. Output Power at 25 Degrees C: 280 W Cont. Output Power at 40 Degrees C: 240 W Efficiency: 88 % No Load Input Current (2): < 100 mA  Current Consumption: < 200uA when disabled via its remote port Galvanic Isolation: 200 VDC between input, output, and case Operating Temperature Range: -20 to +55 Degrees C (derate 3 % per °C above 40 °C) Humidity: Max. 95 % non-condensing DC Connection: Screw terminals Maximum Cable Cross-Section: 16 mm² AWG6 Weight: 1.3 kg (3 lb) Dimensions (H x W x D): 130 x 186 x 70 mm (5.1 x 7.3 x 2.8 inch) Safety Standards: EN 60950 Emission: EN 61000-6-3, EN 55014-1 Immunity Standards: EN 61000-6-2, EN 61000-6-1, EN 55014-2 Automotive Directive Standards: ECE R10-5 Please contact your dealer for any returns, repairs or support issues related to this product. Quick Guide (pdf)Owner's Manual (pdf)Brochure (pdf)

Read more less

Liquid Electrical Tape - Red - 4 oz Creates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Liquid Electrical Tape - White - 4 oz Creates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Liquid Electrical Tape - Green - 1 ozCreates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Liquid Electrical Tape - Red - 1 ozCreates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Liquid Electrical Tape - White - 1 ozCreates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Liquid Electrical Tape - Black - 4 oz Creates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Liquid Electrical Tape  - Clear - 4 oz Creates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Liquid Electrical Tape - Black - 1 ozCreates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Liquid Electrical Tape - Green - 4 oz Creates an airtight, waterproof, and UV-resistant seal on electrical connections and wires. Designed for bilge pumps, outdoor wiring, marine applications, and small electronics repairs. The flexible coating withstands temperatures from -50°F to +275°F and provides superior dielectric protection.Directions:Wires or terminals to be sealed must be clean and dry. Squeeze Star brite® Liquid Electrical Tape onto the electrical connection area. Allow to dry for 5 minutes and apply a second coat if a greater thickness of seal is needed. Additional coats may be applied at 5-minute intervals to build up extremely thick protection. The product fully cures in 24 hours.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Read more less

Flip Pro Plus Fast Charge USB-A & USB-C SocketThe revolutionary ultra-fast combination USB A & USB C charger.Flip Pro Plus is designed for use with either a 12V or 24V input and features 1x 60W USB-C and 1x36W USB-A charging ports for maximum choice and performance. Juggling different devices with different cables? Then this is the option.Features: 12/24V fast charge, dual USB socket Redesign to match other Flip Pro aesthetics Low profile Type A/C dual USB charger The Flip Pro Plus is a combination of Scanstrut's most sought-after chargers, designed to be used with either a 12V or 24V input, and features 1x USB-A and 1x USB-C to create a rapid, universal, ultra-fast charging solution. The Flip Pro Plus is a redesign of Scanstrut’s classic Flip Pro to ensure the boat's aesthetics stay aligned with Scanstrut's other designs in the Flip Pro range.  When not in use, the spring-loaded caps remain tightly closed, protecting the ports from the elements.Featuring a super-compact footprint that matches the rest of Scanstrut’s Flip Pro range, it is constructed from premium, marine-grade materials. Flip Pro Plus has been rigorously tested and is IPX4 waterproof, making it completely washdown-ready.Flip Pro Plus is FAST! It will charge at 36W on a 12V system or up to 60W on a 24V. With a PD chip, this charger is truly universal, making it perfect for charging modern laptops via the USB-C port. It is also designed for charging large tablets, offering an effortless charge for both an iPad Pro & iPhone at the same time.USB – C output: 60W max on 24V system 36W max on 12V system USB-A – A output:36W maxThe install cut-out matches Scanstrut's Flip Pro Max, Duo, and Multi USB sockets (32mm (1 1/8”) for a seamless look across the range. Now users can keep up with the heavier power draws of modern electronic devices while keeping premium, universal USB chargers all around the boat.Universal Universal fit for any USB-A or USB-C connectors Fast charge up to 2 devices at a time Easy Install, using a standard USB mounting hole - 32mm (1 1/8”) Is supplied with an optional front mount bezel Washdown Proof IPX4 waterproof with the cover closed Marine Ready PCB /or electronic with a protective coating UV resistant Plastics 316 stainless hinge and spring Electrical Information Input voltage: 10-30V DC (12/24V System) Input current Max: 6A (10A fuse recommended) Standby power draw: 0.01W Important informationThe charge cable supplied with the device (tablet, phone, action camera, etc) must be used to achieve maximum charge performance from this charger. Phones will charge at the same speed, whether on a 12V or 24V input voltage system. However, a 24V system must be used to get the full 60W output suitable for fast-charging laptops. Specifications: Type: Chargers Box Dimensions: 2"H x 4"W x 4"L WT: 0.2 lbs UPC: 5060114798878

Read more less

Bluetooth Gateway for SG200Optional 39″ Bluetooth® Gateway for Smartphone App.This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.

Read more less