Marine Navigation & Instruments - NMEA Cables & Sensors

NMEA 2000® Multi-Port T-ConnectorMake NMEA 2000 installations easier with our multi-port T-connector. This solution creates a more robust NMEA 2000 backbone by reducing issues with breaking points as well as stress induced by long back bones. The rigid construction is less prone to failure and decreases installation time.WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications: Data Interface: NMEA 2000 Box Dimensions: 1"H x 3"W x 4"L WT: 0.5 lbs UPC: 753759182311

Read more less

Mechanical Contact Carrier Mat/Color: Thermoplastic PUR/Blue-Gray Molded Body Mat/Color: Thermoplastic PUR/Blue-Gray Contact Mat/Plating: Brass/Gold Coupling Nut Mat/Plating: Brass/Nickel Connector Outside Diameter: 0.59"Electrical Current Rating: 4.0 Amps Voltage Rating: 250 VCable Outer Jacket Mat/Color: PVC/Gray Conductor Insulation Material: HDPE (data pair), SRPVC (power pair) Number of Conductors: 4X22 AWG, 22 AWG Drain Wire Shielding (3-Levels): FOIL (Overall), FOIL (Power Pair), FOIL (Data Pair)Environmental Protection Class: IEC IP68, NEMA 1,3,4,6P Temperature Rating: -40 deg C to 80 deg C to (-40 deg F to 176 deg F)Approvals (Cable) UL: PLTC 75 deg C Sunlight Resistant E90625,AWM 80 deg C 300V (Cable) CSA: CMX-OUTDOOR-CMG LL54185 75 deg C,AWM I/II A/B 80C 300V FT4 NMEA: NMEA 2000 Approved Specifications: Cable Length (Feet): 20' Data Interface: NMEA 2000 Box Dimensions: 2"H x 7"W x 7"L WT: 1.05 lbs UPC: 873804001562

Read more less

Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. Specifications: Cable Length (Feet): 16' Data Interface: NMEA 2000 Box Dimensions: 1"H x 8"W x 8"L WT: 0.55 lbs UPC: 723193060360

Read more less

Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. Specifications: Cable Length (Feet): 3' Data Interface: NMEA 2000 Box Dimensions: 1"H x 5"W x 6"L WT: 0.05 lbs UPC: 723193060346

Read more less

NMEA 2000 in-line terminatorWARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications: Data Interface: NMEA 2000 Box Dimensions: 1"H x 2"W x 2"L WT: 0.1 lbs UPC: 753759078430

Read more less

NMEA 0183 with Audio CableNetwork your compatible GPSMAP® chartplotter with this NMEA 0183 data communication cable. Includes bare wires and an RCA connector for audio connection to any stereo setup, including FUSION. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications: Data Interface: NMEA 0183 Box Dimensions: 1"H x 5"W x 5"L WT: 0.4 lbs UPC: 753759218690

Read more less

Spur CableRaymarine 3 meter Spur Cable for SeaTalkng Specifications: Cable Length (Feet): 10' Box Dimensions: 1"H x 7"W x 8"L WT: 0.5 lbs UPC: 723193060407

Read more less

SPL2000 AIS-VHF Antenna SplitterThe SPL2000 allows the boat's VHF antenna to be used for both an AIS and VHF simultaneously. It uses ZeroLoss technology and is suitable for use with AIS Class B transponder systems as well as AIS receivers. It's also designed as a failsafe device with automatic priority given to the connected VHF. It is supplied with a BNC-BNC patch cable for the AIS and a PL259-PL259 cable for the VHF. It also features a AM/FM wired output for an on board stereo receiver. Identical in size to the AIT2000, it makes the perfect complimentary splitter device for Digital Yacht's range of AIS products.

Read more less

Spur CableRaymarine 1 meter Spur Cable for SeaTalkng Specifications: Cable Length (Feet): 3' Box Dimensions: 1"H x 6"W x 7"L WT: 0.05 lbs UPC: 723193060391

Read more less

GA200 GPS Sensor for AIS700The GA200 is an external antenna, suitable for improving the reception of the internal GNSS (GPS / GLONASS) receivers of compatible MFDs, AIS devices, and VHF radios. The GNSS antenna is supplied with a fitted 10 m (33 ft.) cable. The length of the antenna cable can be extended if required. The antenna cable length can be extended by up to 10 m (33 ft.), giving a total maximum cable length of 20 m (66 ft.)

Read more less

NMEA 2000® Backbone/Drop CableExtend your NMEA 2000® backbone with Garmin's 13' (4M) backbone/drop cable.Compatible Devices: AIS™ 300/600 Blackbox Transceiver GBT™ 10 GCL™ 20 Low-light Imaging Camera GDL™ 40 GET™ 10 GFL™ 10 GFS™ 10 GHP™ 12 Autopilot System GHP™ 20 Marine Autopilot System for Steer-by-Wire, Viking® and Yamaha® Helm Master™ GHP™ 20 Marine Autopilot System with SmartPump GMI™ 10/20 Marine Instrument GPS 19x NMEA 2000® GPSMAP® Series VHF 200/300 Marine Radio VHF 300 AIS WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov. Specifications: Cable Length (Feet): 13' Data Interface: NMEA 2000 Box Dimensions: 1"H x 5"W x 6"L WT: 0.4 lbs UPC: 753759978198

Read more less

The TR3K temperature probe is for use with the Maretron TMP100 Temperature Module (optional extra) or the DCM100 DC Monitor (it is included with the DCM100). This probe ends in a ring terminal and can be used to measure battery temperature or any other under-bolt temperature. The temperature range is -4 deg. F to 176 deg. F (-20 deg C to 80 deg C).WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov. Owner's Manual (pdf)

Read more less